Taidacent Power Meter Calibration Power Measurement 1MHz ~ 10GHz -50~0dBm Power Attenuation Value Can be Set

For an inexpensive power meter this is quite good. Get a 20 dB SMA attenuator so you can measure power up to 100 mW. But the unit is reliable and very easy to use.

I built a handy RF level tester by mounting this circuit board in the plastic case which it was shipped in. Comparing its readout with that of some signal generators, I believe that it is pretty accurate except when getting to the measurement extremes. In other words, when the applied signal lever approaches 0dBm or -50dBm, amplitude reading isn't as accurate. In the middle of the amplitude range it seems pretty good. With use of external attenuators, its upper range can easily be extended. This has become a handy checker of signal generators that I work on and other oscillator devices.

Love this product, you can use it as a power meter to measure the attenuation for a RF switch . Highly recommended.

I spot calibrated it with a signalhound tracking generator in CW and spectrum analyzer at -10, -20, and -30 dBm.consistently reads 3.5+/-1 dB hot over 1 GHz to 3 GHz, but with a bit of work you could probably create curves that got you within half a dB of truth.Haven't tried it with a modulated input yet.

I found this to be accurate. The reason for the 4 stars is that it does require effort to package the unit.

This unit exceeds my expectations which is something I rarely am able to state . Great job guys !!

Very accurate and easy to use.

This is a fairly decent cheap little power meter for checking power levels. This isn't going to beat an HP/Agilent/Keysight power meter sensor, but its better than nothing if you don't already have one.A downside that it has is between -40 to -50 dBm the readings jump a lot. at -50 dBm, using a 3336C level generator the meter was jumping 2-3 dBm and was not reading -50. It appears to have its limitations, but at least down in the 1 MHz to 20 MHz range is was reading the same.